|
Rosco Ultimatte Super
Blue is a darker, purer blue than Ultimatte Blue. It is designed primarily
for use in shooting film for Ultimatte compositing. It permits sufficient
separation in the blue and green channels without having to saturate the
blue layer of the negative. The result can be less noise in the telecine
transfer. In addition, it can be used to reduce glare on horizontal
surfaces that might interfere with a clean matte.
FINISH:
Matte
SOLVENT:
Water.
BINDER TYPE:
Vinyl Acrylic.
DILUTION:
Use straight out of the can.
If necessary, dilute with water. Diluting Ultimatte paint may make coverage less even.
SURFACE
PREPARATION: Surfaces should be clean, dry and free from dirt and grease. Prime porous surfaces,
except fabrics, using Rosco Tough Prime. If painting a new plaster surface, prime wall
with a commercial primer/sealer designed for raw plaster. Then use Rosco Tough prime as a
final preparation.
APPLICATION:
Stir contents before use. Do not shake. Apply by brush, roller, or spray gun. Apply in
thin, even, uniform coats, using a good quality brush or roller. Use overlapping strokes,
keeping a wet edge. Change roller direction often to avoid patterns and streaking.
FILM THICKNESS:
2 mil. Dry Film.
COVERAGE:
Appx 300 sq. ft. per gallon.
AVG. DRY TIME:
AT 75°F (24°C) Dries to the touch in 30 minutes. Can be re-coated in 1-2 hours.
CLEAN-UP:
Soap and water.
SHELF LIFE:
Minimum 24 months.
PACKAGING:
1 Gallon Cans and 5 Gallon Pails.
COLOR SPECIFICATIONS:
| Video
levels when 89.9% white is at 100. |
Red |
Green |
Blue |
| #05720
Rosco Ultimatte® Blue |
22 |
40 |
82 |
| #05722 Rosco Ultimatte® Super Blue |
7 |
18 |
72 |
| #05721
Rosco Ultimatte® Green |
29 |
84 |
36 |
| These values were measured
with an Ikegami EC-35 camera with Plumbicon tubes. The iris was set so that an 89.9%
reflective chip on a Porta Pattern 11 step chip chart was at 100IRE units. The gamma was
set to 0.45 and the knee circuit was turned off. Different cameras may yield different
levels even under the same conditions. |
CAUTIONS:
Do not apply when surface or air temperatures are below 50°F. Keep from freezing. Avoid
prolonged contact with skin or breathing of spray. Do not take internally. Use adequate
ventilation. KEEP OUT OF REACH OF CHILDREN.
|
